Maintenance of standard automotive parts is a very meticulous work, each damaged standard parts of the car need careful maintenance and care, so as to achieve our desired results, to extend the service life of the mold.
Automotive mold standard parts
Punches, punches: the punch on the standard parts of automotive molds, punching most of the standard parts, the punch in the automotive mold prone to breakage, bending and gnawing bad phenomenon. Punches are generally gnawed bad punch and red sleeve damage are generally replaced with the same specifications of the parts.Punch the main parameters of the working part size, the installation part of the size, length and size.
Tighten the parts: Check the fastening parts are loose, damaged phenomenon. The solution is to find the same specifications of the parts to be replaced.
Pressing and unloading parts: Pressing parts such as pressure plate, gifted plastic, unloading parts such as unloading board, pneumatic jacking device. Maintenance inspection of the various parts of the assembly relationship and whether damaged, the damaged part of the repair. Pneumatic top check whether the leak, and to take specific measures, such as tracheal damage to be replaced.
Spring and other elastic parts: In the process of using the spring is one of the most vulnerable parts of automotive molds, usually fracture and deformation phenomenon. The solution is to replace, but the replacement process must pay attention to the spring specifications and models, the spring Specification model by the color, diameter and length of three to determine, only in the case of these three are the same can be replaced. 【Suzhou mold design】